This is a soap dish with the words "DIRT REMOVER" engraved into it

Tools needed: none

Additional parts needed: none

Recommended filament: PLA, PETG

Hotend: 0,40mm

Print time: 1h

Print instructions:

layer height 0,20mm
2 wall loops
top/bottom shells 4 layers
top/bottom shell thickness 0,80mm
sparse infill 15%
sparse infill pattern “grid”
Before printing:

Make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For a good build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Bad build plate adhesion is not related to the model.

Please check out my other models https://makerworld.com/en/@BigEnnn and leave me a like and a decent rating if you were satisfied. Thank you in advance!