I did a remix of PaulBPunkt TreeFrog. This model has on AMS and uses two 6x3 mm magents. They are a bit oversized so the magents fit in easily. This means you will need to superglue them into place. The 3mf file has 6 frogs on the plate.
three amputees and one failed. but I filled the bed to minimise on waste to finished goods ratio and it was well worth it . highly recommend giving this a go. .. hole for 3x6 magnet a little too big . glue was easily applied but would have preferred a push fit
P1S - I squeezed 20 on the build plate
1 tried to come back from the ooze and 3 amputees led to some stringing around the bed but a very nice print .... I'd probably. just need to clean. my build place for a perfect run or increase the bed temperature a few degrees to improve on this
Comment & Rating (24)