infinity cube
Copyright Claim
infinity cube
Boost
35
68
26
Print Profile(1)
0.2mm layer, 2 walls, 5% infill
Designer
1 h
1 plate
Boost
35
68
26
0
178
246
Released
Comment & Rating (26)
All
it’s hard to take it off the bed
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
nice
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
printed direct from handy, but the brim was very difficult to remove completely and the supports were stuck in there very tightly, after all removal, the motion is still crunchy, I'm not sure where the problem lies.
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
supports were overdone
1
Reply
I did a plate of 8 right from the makerworld app and it put brims on them...
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
it is very fidgety (good) but you can’t use it right away off the print
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
I didn’t like the supports
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
nice
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
great for printing, fast and easy. a little resistance but works great
1
Reply
Print Profile
0.2mm layer, 2 walls, 5% infill
Great toy
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld