Coffee Filter Paper Holder
Copyright Claim
Coffee Filter Paper Holder
Boost
17
28
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
17
28
9
2
32
34
Released
Description
A holder stand to store coffee filter paper (size 1x4) up to 100.
Update (v2) 09 May 2024: improved the bottom edge for cleaner surface. Special thanks to @MochaFanatic10 for pointing this out for me!
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Love the design and printed pretty well, except for the jaggedness on the top. Not sure if it’s due to layer height or if maybe the 3D model needs higher resolution? Thanks for sharing 🙏
The designer has replied
1
Reply
Thank you for the comment. I've been thinking about this for a while. I was going to suggest to use matte filament as the layer edges catch less light but looks like you are using that. As you say the layer height can be made smaller to ease this problem but I've not tried. The 3D mesh itself is relatively smooth. I imagined about angling the whole mesh to have nicer angle for the top edge maybe, but not had a chance to try that. Angling the mesh would require supports through so the surface might be disturbed, but maybe worth a try.
(Edited)1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Die zweite Layer wurde in der Luft gedruckt und deshalb war der Boden nicht so schön 🤨
sonst war der Druck wunderschön👍
The designer has replied
1
Reply
Hi @MochaFanatic10 ! Thank you very much for pointing out the problem! You are right that the bottom layers were not very clean. This was down to the way I applied the smoothing to the mesh. I have improved the mesh and updated the upload file here.
Comment like yours gives me a chance to learn! I appreciate your post with image very much! Thanks again!!
0
Reply
Boosted
Since I think the model is so great and you are very friendly, I would be happy to boost your model
The designer has replied
1
Reply
oh that's so kind! Thank you again :) :) you made my day!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out brilliantly
The designer has replied
0
Reply
Thank you for the comment!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sehr gut
1
Reply
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld