This stand requires the following materials:

~5 feet of 1 and ¼ inch wooden dowel

~180 grams of filament

-14 #6 screws, ¾ inch long (change length as supplies allow)

Steps:

1. Slice the files provided. The only parts that require support are marked as such, organic supports worked best on these.
2. Cut the wood to the lengths outlined below.
3. Put the 13 and 8 inch pieces of wood together as shown below. Drill pilot holes and screw in the #6 screws.
4. Place the 12 inch sections inside the holes, screw in the FootHolder pieces on the front, and screw in the Foot pieces at the back. Slide these sections back and forth to fit the bass, then screw in when happy with location.