Created mainly so I can fit in KevinAkaSam's Tridender skirts https://www.printables.com/model/428500-tridender-skirts-for-ender-3prov2

It should fit any mainboard that has the holes for the bolts in the same spots as the stock Ender 3 mainboard.

You are going to need 8 M4 bolts and nuts to secure the plates in place. The plates provide some wiggle room (around 2mm).

You will also need some M3 bolts to bolt in the Pi and Mainboard - standoffs are provided, you can scale them to easily fit the bolts through them and hold in the boards with nuts or you can leave them as they are and screw the bolts into them from both sides, they should be very tight fit.

The bolt holes allow you to move the Mainboard and Pi after bolting them in, if you need to space them out a bit or something.

The fan holder can be mounted on the bottom side of any extrusion, it requires two M5 T-Nuts and bolts. You could use a second one to put in a Pi fan I suppose.

tldr:
- 8 x M4 bolts
- 8 x M4 nuts
- min. 8 x M3 bolts
- 8 x M3 nuts
- 2 x M5 bolts
- 2 x M5 nuts

If you need to fit anything else in, like a different board or some buck converters, feel free to remix!