PocketDriver - EDC Hex Bit Screwdriver w/ Storage by Downloaded Goods

Downloaded Goods

Tools>Hand Tools

Print Profile(6)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

2 h

2 plates

4.9(59)

PLA 0.2mm layer, 3 walls, 25% infill

2.2 h

2 plates

5.0(6)

0.2mm layer, 2 walls, 15% infill

2.7 h

2 plates

4.7(7)

Strength Profile, 0.2mm layer, 5 walls, 25% gyroid infill

1 h

1 plate

5.0(6)

Click to see more

Boost

383

605

756

493

Released

Description

The PocketDriver is a sleek and practical EDC bit driver designed to hold up to 4 bits within its body.

It comes in 2 versions, a Large (can carry up to 4 bits) and a Medium (can carry up to 3 bits). Printing it is super easy, just make sure to have a brim and good bed adhesion so that the body doesn't fall mid-print.

At the base of the bit socket, there's room to affix a 6x2mm round magnet (a 5x1mm magnet also works). The model features 0.3mm tolerances for the bits, though depending on your printer and material, it may be slightly snug. If needed, using pliers to insert and remove bits a few times can help loosen the slot.

If you would like to see more models like this, consider giving it a boost 🚀🚀🚀 .

It helps me buy filament and material to prototype and test new models!

Happy printing!

Comment & Rating (90)

@mofaslp

Bits gehen sehr schwer rein, hab ihn dann etwas mit Kraft eingedrückt, raus hab ich ihn nicht mehr bekommen musste dann den Schraubendreher kaputt machen damit der Bit wieder rausging

(Edited)

The designer has replied

@DownloadedGoods

oh no! unfortunately different printers have different dimensional accuracies. try scaling it up in your slicer. it should resolve it.

@DownloadedGoods

Ich habe eine Version mit lockererer Passform hochgeladen

@AshleyHKS

Print Profile

0.2mm layer, 2 walls, 15% infill

printed really clean

@TheRoyalTed

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed really clean and solid. Everything fits just right with no adjustments. I'm curious about the longevity of this, but so far it feels good and doesn't feel like it will break easily when using it.

@Makerspace.NL

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

hope it’s strong enough to hold up for a bit (pun intended ;) )

@3DParts.at

Print Profile

PETG and PLA 0.2mm layer, 3 walls, 15% infill

Print with PETG

@karol7162

Print Profile

0.2mm layer, 2 walls, 15% infill

The designer has replied

@DownloadedGoods

Awesome finish! What filament did you use?

@karol7162

Replying to @DownloadedGoods :

It’s the Prusament PLA Galaxy Black. It gets a nice shiny finish when you dial down the speed. And the green is just some random PLA I found in a sample pack :P

(Edited)