DarwinFPV Baby Ape Walksnail Avatar HD 1S mini by Luca Rubino

Luca Rubino

Hobby & DIY>Other Hobby & DIY

Print Profile(1)

All

0.2mm layer, 2 walls, 100% infill

Designer

11 min

1 plate

Open in Bambu Studio

Boost

Released

Description

Here is my new version of the camera stand for use with a Walksnail Avatar HD 1S mini.

Printable in PLA or PETG (not TPU).

This new mount is a little shorter than the previous version and I raised the holes slightly to have a better view and not have problems with the camera tilting.

Here you could find the Antenna mount: https://makerworld.com/en/models/446677

Other Baby Ape parts

Here's my analog version: https://makerworld.com/en/models/119467

Do you need a buzzer mount? https://makerworld.com/en/models/392143

Comment & Rating (4)

@fady

what's the difference between this bracket and the other one you modelled ?

The designer has replied

@luca.rubino

This one is especially made for the Avatar HD 1S lite system. It's a little bit shorter. The camera is a little bit higher because it's different from the analog camera. Allowing you to tilt as much as you would. And no bracket in the field of view because it's 170 degrees of FOV.

(Edited)