TP4056_Box_All_Holes.stl The TP4056 charger box with all holes for the available wires on the board. A headache if printed with supports
TP4056_Box_No_Cables.stl Just the box with hole for micro USB. You have to make the holes for wiring.
TP4056_Magnet_Holder_bridged.stl Magnet holder part with hole for 8mm x 1mm magnet
TP4056_Magnet_Holder_bridged_deep.stl Magnet holder for 2 8mm x 1mm magnets
TP4056_Whole_Lid.stl Top lid with no holes
TP4056_Wholed_Lid.stl Top lid with holes for cooling
TP4056_Magnet_Holder.stl Magnet holder without bridging for wires

You might have to sand the lid a bit to get the best fit.
Watch the video to see all the steps in finishing the charger.
For coloring the magnet holders, please watch the other video.