Show off your love for the Wyoming University Cowboys with this aerial shot of the stadium. Made in Hueforge, this is a four-panel print that is best displayed mounted on the attached frame. This is a long print (~38 hours), but totally worth it once you get it hung on your wall.

Printing Directions:

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.08mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Transmission Distance: 4
PLA PolyLite Starlight Jupiter Transmission Distance: 1.5
PLA BambuLab Matte Latte Brown Transmission Distance: 2
PLA+ Sunlu Grass Green Transmission Distance: 3
PLA PolyLite Grey Transmission Distance: 1
PLA PolyLite Yellow Transmission Distance: 11
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #15 (0.64mm) swap to Blue
At layer #19 (0.8mm) swap to Starlight Jupiter
At layer #20 (0.84mm) swap to Latte Brown
At layer #21 (0.88mm) swap to Grass Green
At layer #26 (1.08mm) swap to Grey
At layer #31 (1.28mm) swap to Yellow
At layer #38 (1.56mm) swap to Jade White for the rest.