This spinning bowtie is a must-have accessory for any maker. From school to work to other formal events, this bowtie is sure to make you stand out anywhere. It is recommended that it be printed in bright orange filament for optimal standoutedness.

Print one bow, one support, and two clips
Assembly:

1. Print all of the pieces, please note the clips are designed to be printed or laser cut.
2. Using a small bit of hot glue, attach the clips to the back of the support in the two included channels.
3. Carefully hammer a standard 608 bearing into the center of the bow
4. Press the bow on to the front of the support (you many have to add hot glue here as well).
5. Clip it on, adjust, and engage in stylish shenanigans!

Notes:

• It also comes with an included spot to thread a ribbon band through, though I have yet to get it to work as well as the clip on configuration
• I recommend, should it sit at weird orientations, adding small weights to the back in the form of small flat pushpins glued near the bottom, as it helps balance
• This is definitely still a prototype, it doesn't work perfectly yet. The clip is also a little tight.