Roku Remote Holder
Copyright Claim
Roku Remote Holder
Boost
14
10
17
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
1.1 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
50 min
1 plate
Boost
14
10
17
5
37
64
Released
Description
We kept losing our remote to the couch cushions, and I was tired of moving the couch to get it off of the floor. I designed this holder for the Roku remote to mount on our couch side tables. I used a small strip of VHB tape to mount it to the table.
Comment & Rating (17)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect fit. Easy print.
0
Reply
surprisingly fit my spectrum tv remote! thank you
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
printed quick and well, maker is very nice and helpful. He made a new print profile for A1 mini and said he would do that for all his prints in the future that fit on the build plate
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
looks good thanks for the rating
0
Reply
Boosted
is there anyway you could make an a1 mini print profile?
The designer has replied
0
Reply
Yep. From now on I will make sure to make my models that are small enough compatible with the mini. Thanks for pointing that out.
0
Reply
Boosted
Replying to @orangeflow
thank you! don’t worry about making all of them small enough though
0
Reply
Replying to @golferbobert
I won’t. I will just make sure that there is a profile if the models will fit. Part of the point of this platform is ease of use.
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
printed as it should
The designer has replied
1
Reply
Thanks for the boosts! Means a lot!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
this print is perfect. however this doesn't work on the new 55“ Roku tv remotes. the print however is solid and very well done!
(Edited)The designer has replied
0
Reply
Your remote has a straight line of buttons? Or it it like the one in the picture?
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Perfect print!! Thank you for sharing!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld