I created a travel case to hold q-tips and flossers. It is compact and should easily fit into a toiletry bag.

This model does not require any hardware like some other cases that are posted on here. It is all snap in place.

There are 3 parts, the top, bottom and latch. I have the print profile set up with two different options, one where you can print all of the parts at once but all the same color. And then another where you can print the top and bottom one color and the latch another on a different print.

All of the snap fits are meant to spin somewhat freely. Be careful removing the support and make sure you get it all off. There are a couple of strands that like to stay on the bottoms of the shafts, shown in the picture below.

Good luck printing!