Car Phone Holder v3 - Remix - Universal Ball Mount
Remixed by
Boost
20
38
7
Print Profile(2)
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
Designer
4.4 h
4 plates
Remixed Parts Only - 0.2mm layer, 2 walls, 15% infill
Designer
58 min
1 plate
Open in Bambu Studio
Boost
20
38
7
1
80
51
Released
Description
I am a huge fan of Duane777's design for the phone holder v3! Unfortunately my car has vent positions that make this very awkward. So, I remixed to include a ball mount and a universal plate that can be mounted with 3m tape anywhere with a flat surface.
Instructions
- Insert the ball part bottom-first through the nut.
- Screw the base-plate to the bottom of the ball-part. You may want to add some super glue here as turning the nut may have a tendency to spin the entire cylinder once you have mounted
- Depending on the weight of your phone, you may need to line the ball mount with something like teflon tape. Mine worked fine printing as is, since I have made the washer part of the nut.
Comment & Rating (7)
All
Print Profile
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
All of the parts went well and fitted pretty good.
0
Reply
came out perfectly👌
(Edited)
0
Reply
Print Profile
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
Easy print. Making more for all my cars :-)
What size screws do you use?
I ended up using m3x8 screws and a little super glue but they are pretty tight.
(Edited)The designer has replied
1
Reply
Glad those worked for you. I just grabbed a couple off a broken kid toy that we were getting rid of. I am no sure the exact size but they were pretty small overall.
0
Reply
Print Profile
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
printed without a problem
0
Reply
Print Profile
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
All Parts - Remix - 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld