Support Free/Hardware Free Soft Measure Tape Spool Remixed by Halfway_Engineered

Remixed by

Halfway_Engineered

Tools>Organizers

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

51 min

1 plate

4.7(30)

P1 Profile - 0.2mm layer, 2 walls, 15% infill

45 min

1 plate

4.5(2)

Open in Bambu Studio

Boost

138

288

226

Released

Description

An enclosed spool for a 13mm (0.5in) wide soft tape up to 150cm (60") comprised of four pieces: an inner and and outer top and bottom.

Assembly Instructions

Place the inner bottom piece down on a flat surface.
Fit the outer bottom piece over the inner bottom piece.
Place the end of your soft tape into the slot on the inner bottom piece.
Fit the outer top piece in place by pressing it into the matching groove on the bottom piece.
Place the inner top piece onto the spool assembly, taking care to line up the slot for the end of the soft tape. Press firmly to secure.

NOTE: The pins on the bottom piece often break when attempting to take the inner pieces apart. Do NOT join the inner pieces until final assembly.

maker

sewing

tapemeasure

Comment & Rating (35)

@nuclearstar

Great print, Creality K1C PLA, fast print no problems at all, works great

@user_2166852130

Print Profile

0.2mm layer, 2 walls, 15% infill

Took a little muscle to click together but it comes together great! Accidentally broke it the first time and had to reprint two pieces.

@MeetYourMaker

Print Profile

0.2mm layer, 2 walls, 15% infill

Very nice! Works great!

@TomNL

Print Profile

0.2mm layer, 2 walls, 15% infill

Works great. Thanks.

@user_869389027

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Works perfectly

@loiseaucreatif

Print Profile

0.2mm layer, 2 walls, 15% infill

Practical tool, prints quickly and fits together very well

@udovichenko.k.s

Print Profile

0.2mm layer, 2 walls, 15% infill

nice model

@FancyBananaMan

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:The outside parts fit nicely, and the inner parts fit into the outer parts well, but the inside parts do not fit together at all, so the whole model cannot be put together without modifications. I would suggest making the snapping lock mechanism thinner so it can actually flex to fit into the hole.

The designer has replied

@Half_Engineered

@FancyBananaMan Hello, sorry you're having troubles. Please try pressing the two pieces together against a hard flat surface. I did not design the joinery, only remixed it to this design. The original designer intended for this joint to be stiff and permanent.