Sanding Disc Dispenser 125mm (stackable)
Copyright Claim
Sanding Disc Dispenser 125mm (stackable)
Boost
40
98
20
Print Profile(2)
0.24mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
0.2mm layer, 2 walls, 50% infill
52 min
1 plate
Open in Bambu Studio
Boost
40
98
20
1
84
107
Released
Description
Remix from Jake_social's Sanding Disc Dispenser. Thank you!
This version uses less filament and is stackable.
Comment & Rating (20)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
hat gepasst, gut
The designer has replied
1
Reply
Freut mich!
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
easy. fast. clean
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Top 👍🏼
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
printed nicely, but base is a bit too thin imo
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Works
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Strength Issue:The print has broke while detaching from the cool plate, which should not happen. Still the print is fully finctional.
The designer has replied
0
Reply
Thanks. But that sounds more like you have no patience until it has cooled down. Or you removed it by force. Or bad filament. Depending on the filament and printing plate, there may also have been a lack of adhesive and it stuck too much. Or a combination of all that.
I have printed dozens of them on several printers from Creality, Prusa, Voron Trident and on my Bambu.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld