I've created this storage Box for my AirUP flavor pods because they were laying around everywhere before.

I wanted to create an easy to print box with a lid.

I used the following print settings:

Infill: 10% support-cubic
Support: tree support (If you feel good with your bridging, no support should be needed)
Layerhight: 0.16

There are two lids included. One is the single color lid, the other one is with a seperate letter file, so MMU color print is possible. Just choose which one fits better.


Also, I've included my TestPrint file, just because I have it. I've used it to test the pod fitting.


Any suggestions for improvements or any other feedbacks are much appreciated.