iPhone 12 Pro Max Case
Copyright Claim
iPhone 12 Pro Max Case
Boost
30
46
31
Print Profile(2)
0.12mm layer, PETG
46 min
1 plate
0.12mm layer, 2 walls, 25% infill
59 min
1 plate
Boost
30
46
31
1
290
221
Released
Description
NOT MADE FOR TPU.
I made an iPhone 12 Pro Max case that supports magsafe charging. I tried printing other cases, but determined that they all were too thick for my liking. I therefore made a case that was only 1 mm thick.
I print the case in two parts and then glue the camera bump on to be able to print without support.
Printed in black PLA. 0.12 layer height, 100% infill, 0.6 nozzle.
Comment & Rating (31)
All
Print Profile
0.12mm layer, PETG
very simple and easy 1st time print for beginners
0
Reply
Print Profile
0.12mm layer, PETG
worked well on my P1P without any tweaking. used Bambu basic PLA
0
Reply
Print Profile
0.12mm layer, PETG
my first tpu print, but it's very good
0
Reply
Print Profile
0.12mm layer, PETG
it is ok but not for TPU… i will try to petg
The designer has replied
0
Reply
The Autor said TPU but this is my profile for PETG :)
0
Reply
Replying to @lorenzofabbri95
Hi.
I printed in PLA. The model is not made for TPU. If someone would like to print it with TPU I would imagine it would need to be scaled down somewhat.
0
Reply
Print Profile
0.12mm layer, PETG
did not fit iphone 12 printed on tpu
0
Reply
Hi. I have my self used PLA only on this model. Printing a case like this in TPU would normally need the model to be scaled down because it is strechy. I don't know how this would affect the buttons though.
0
Reply
Print Profile
0.12mm layer, PETG
Printed this for hubs cell phone. He loves it! We couldn't figure out how to get the camera square to stay on, but itnreally isn't needed.
0
Reply
Glad you liked it! I glued the camera square to the case with some epoxy or superglue.
0
Reply
Print Profile
0.12mm layer, PETG
Support Issue:failed where the volume buttons are without supports
1
Reply
Sorry for the late response. I have my self not had any issues with bridging where the buttons are. It is unfortunate that this happened to you.
0
Reply
I also had the same issue with the volume buttons. printed in black petg basic.
0
Reply
Boosted
Amazing snug fit
0
Reply
Print Profile
0.12mm layer, PETG
broke when I put my phone in
0
Reply
Print Profile
0.12mm layer, PETG
perfect fit
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld