Insta 360 Go 3 Camera Mount
Copyright Claim
Insta 360 Go 3 Camera Mount
Boost
1
8
5
Print Profile(2)
Single Color 0.2mm layer, 2 walls, 15% infill
Designer
45 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
Boost
1
8
5
0
18
6
Released
Description
I was commissioned to make a mount that goes on top of a camera for an Insta 360 Go 3 and this works so well! Post pictures of yours! You will need 8x2 magnets they are $5 on amazon for 100 of them.
Comment & Rating (5)
All
Print Profile
Single Color 0.2mm layer, 2 walls, 15% infill
fits nice and snug. works as intended!
The designer has replied
1
Reply
LOOKS AWESOME!!!!
0
Reply
It works amazing with 8x2 magnets glued in!
1
Reply
Print Profile
Single Color 0.2mm layer, 2 walls, 15% infill
Great design. I found the fit to be just a tad too tight. Not sure the magnets are required due to how hard it is to place and remove the Go 3.
(Edited)The designer has replied
1
Reply
Yes it meant to be a tight fit so there is no way for it fall out if you bump something or don't have magnets to hold it in.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld