Key chain paper dispenser for Washroom by Numimadosa

Numimadosa

Tools>Other Tools

GIF

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

19 min

1 plate

5.0(3)

Boost

Released

Description

Was asked to make this paper dispenser key for a friend who had lost his, so that he wouldn't have to buy a complete set.

I had decided to make it into a keychain and i made it as a skull as i found it looked cool.

Maybe this could come in handy for some other workplace.

paper towel dispenser

Comment & Rating (6)

@lindenaho

Print Profile

0.2mm layer, 2 walls, 15% infill

swap these out for the ones I have at work because they're just cool. The blade is a little on the thin side but other than that fantastic work.

(Edited)

The designer has replied

@Numimadosa

thanks for the rating and the feedback. yes it is a little thin. But, it was the best of all my other tests. This one actually works fine. as long it is printed in horizontal position to support the stress of push it down. Have a great day!

@lindenaho

yes, definitely print horizontal. a vertical print would probably just snap along the layer line. thanks again for the model and the work. great piece.