Threaded egg with a surprise hand Remixed by Rachel

Remixed by

Rachel

Household>Festivities

Print Profile(4)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.16mm layer, 3 walls, 13% infill

Designer

1 h

1 plate

4.8(59)

Fixed Wall Generation-0.2mm layer, 2 walls, 15% infill, 125%

1.4 h

1 plate

4.9(16)

0.16mm layer, 3 walls, 13% infill

1.3 h

1 plate

4.0(12)

0.16mm layer, 3 walls, 13% infill

1.4 h

1 plate

Open in Bambu Studio

Boost

136

186

511

536

Released

Description

Just an egg with a surprise inside

Comment & Rating (93)

@user_1514718718

Printed the OP's and there were holes in the top shell of the egg. make sure you print the one that states it corrected that error in the comments

@user_2487772254

I did the original as a test print and had the same issue will print the remix with thicker walls. PLA multi color silk

@Andinger

Print Profile

0.16mm layer, 3 walls, 13% infill

Not perfect but cool

@Smerk

Print Profile

Fixed Wall Generation-0.2mm layer, 2 walls, 15% infill, 125%

Perfect! Easy print, everyone at work loved it. I left it in the office so nosy people would find it and open it. Got quite a few laughs out of it.

@user_4166453894

Boosted

Print Profile

0.16mm layer, 3 walls, 13% infill

Printed without issues in Inland true red PLA+. The stringing seen is a printer issue, not a design.

@NXNnation

Print Profile

Fixed Wall Generation-0.2mm layer, 2 walls, 15% infill, 125%

Separated the finger from the bottom shell and added a cylinder/negative part to fit the finger onto so that it was centered. Did it this way so I could print by object on one plate without wasting any filament.

@Magnusjr

Print Profile

0.16mm layer, 3 walls, 13% infill

l’idea è molto bella ma la base della parte superiore dell’uovo non viene stampata bene e rimangono dei buchi. ho fatto 3 prove stampando anche più piano ma non si risolve poi ho visto che nelle foto del profilo di stampa c’era già il problema. Peccato perché il resto viene stampato perfetto