Tape support for the IKEA Skadis board
Copyright Claim
Tape support for the IKEA Skadis board
Boost
40
135
7
Print Profile(1)
Vertical - 0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
40
135
7
1
120
60
Released
Description
A simple tape support for IKEA Skadis board.
Printed in PLA with nozzle 0.4,
Standard CURA config, but with tree supports.
Comment & Rating (7)
All
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
Strength Issue:Die drei Haken brechen sehr schnell ab. Da sollte nachgebessert werden! Sonst ein gutes Modell.
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
Missing Model Parts:fails ar the top both times
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Vertical - 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld