Just a stand I mocked up and printed to solve a small problem of wanting to put ice cream cones back in the freezer to solid up chocolate topping. Clearly a big problem plaguing humanity.

Basically this is just a quick knock up of a design that is made for the ice cream cones that we have been using (but expect its somewhat standard - aiming to hold them at the 42mm diameter mark and 75mm high.

The first version I printed I just printed at draft quality of the 3 cone holder and it was pretty easy to bend in the middle so I added a small bit to strengthen (it still only needs to hold up 3 ice cream cones). The 2 cone one is very sturdy for an ice cream cone holder.

The bigger one BARELY fits on a normal prusa bed but it does fit. I printed it out with a brim and it took about 6+ hours, so overnight. The smaller one is only a little quicker (and possibly still overkill for supports, if I go back to it again I might just make the whole thing more honeycomb like to reduce material required, but for now good for drips)

Make sure you print it in something food safe too, just to be safe.