Soda Can Coaster | Perfect Center Fit
Copyright Claim
Soda Can Coaster | Perfect Center Fit
Boost
0
0
2
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
47 min
1 plate
Open in Bambu Studio
Boost
0
0
2
0
1
2
Released
Description
This model varies from my Soda Can Koozie to be used as a perfect-fit coaster so the can sits right in the middle and won't fall off as easy. And of course a quick pattern around the edge! Overall diameter is 90mm to allow for some wiggle room, while the middle of the can sits on a raised section, with a diameter of 44.5mm and a height of 5.5mm with a filet going all around.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld