A simple grommet-style drawer pull. The external diameter of the female (front) portion of the pull is 33mm so they will fit easily into a 35mm (1 3/8") hole. The act of screwing them into each other will tighten them against your drawer so they won't move.

As the front and rear flange diameter is 41mm this means that these will fit holes anywhere from a clean 33mm up to an estimated 38/39mm.

As for drawer face thickness, these will support a max of about 31mm (my use case) down to 21mm.

Very forgiving model as the threads are very large but my settings were as follows:

• Printer: P1S
• Filament: Bambu Basic PLA
• Layer Height: 0.12mm (probably could go thicker here)
• Walls: 4