Sovol Filament Dryer Seal Spacer
Copyright Claim
Sovol Filament Dryer Seal Spacer
Boost
12
19
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
13 min
1 plate
Boost
12
19
7
0
18
11
Released
Description
I wasn't happy with the sealing of the Sovol filament dryer so I fixed it.
This was designed to be printed with TPU. It's a 0.5mm spacer that sits UNDERNEATH the silicon seal of the Sovol filament dryer SH01, since I didn't want to throw the seal away (Silicon will seal much better than TPU - the silicon seal just isn't thick enough).
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Functions as expected. Easy to print and insert into the dryer. Great job!
0
Reply
you, my friend, are awesome. I was very annoyed at the lack of sealing from the top lid.
The designer has replied
0
Reply
Thanks! I’m glad it’s of use to someone :-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed with a bunch of slow settings I found here for TPU:
https://www.reddit.com/r/BambuLab/comments/118a9jc/tpu_progress_finally_good_settings_on_my_p1p/
Printed perfectly.
Oh, I also changed the layer height to 0.16666667, so that 4 layers would exactly = 0.50, the height of this gasket.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I think it was helpful
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
adds a much better seal, thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld