20. Mar. 2024 V1.0:

• First release

Based on DUMMY 13 Beta - Oct. 2023

DUMMY 13 loves COMIC CON!

So I have started to design a whole series of characters and costumes for DUMMY 13. This is another character from the series "DUMMY13 goes to COMIC CON".

The aim is to preserve the charm and simplicity of Dummy 13.

Original DUMMY 13: /models/183780

Get more: /@Mici/collections

----------------------------------------------------------------------------------------------------------------

Content of Locutus of DUMM, sorry Locutus of borg:

• Mask
• Head laser mount
• Armor
• Hand

Printing:

The 3MF file provided has been carefully tuned and can be used with Orca Slicer/Bambu Studio.

Print profile:

• The profile now contains all the parts you need
• Optimized for long service life, rigidity and prevention of adhesion losses
• No need for speed settings
• Don't forget to clean the plate first
• Aligned the parts visually as they are to be assembled

Further details can be found in the profile

Assembly:

Most of frame parts have runners for better adhesion. Remove them.

• Mask:
  • Check and widen all holes with a piece of filament.
  • Use a piece of TPU filament
  • Put on the laser holder
  • Push the end of the filament into the hole in the mask
  • Do not go too far. The inside of the mask MUST remain flat
  • Glue the mask to the head
  • Glue the laser holder onto the mask
  • Insert the other end of the filament into the back of the armor.
  • Use a piece of red filament as laser

• Armor
  • Use two pieces of TPU filament and connect the two holes on the armor with the two holes on the lower chest
  • Use the length that gives you the best look
  • You will need tweezers
  • Use glue if necessary