This is my version of a poop bucket! Works for X1! Can be used for P1 but the magnets don’t stick to the backside!

The model consists of: 1 part

Tools needed: none :-)

Additional parts needed: 4 pcs. neodymium magnets 10x3mm

Assembly instructions:

Press the magnets into the holes. They should fit tight. If they are loose, use a drop of your preferred glue to glue them in.

Recommended filament: PLA

Hotend: 0,40mm

Print time: 6h 55m

assembly time: 1 minutes

Print instructions:

• layer height 0,20mm
• 3 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• sparse infill 15%
• sparse infill pattern “gyroid”
• enable support
• Support type “normal manual”
• Support style “default”
• now paint the bottom side, where the overhang angle is highlighted by 30
• support/object xy distance 1,00mm
• outer brim only

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.

Bad build plate adhesion is not related to the model.

Please check out my other models https://makerworld.com/en/u/1597610120 and leave me a like and a decent rating if you were satisfied. Thank you in advance!