A fun replacement cap/lid for a standard sharpie, it just slides on. Carrot-themed since it's Easter season. It can be used as a replacement cap or fit on the back of the sharpie for a fun little addition.

Print Guide:

Prints in multiple pieces, one carrot body and three leaves. The leaves can then be inserted and glued into place.

Walls/Perimeters: 2 doesn't need to be strong but I don't think one wall would cut it

Infill: Any. There is only a small amount of infill so this shouldn't matter too much

Supports: None

Layer Height: Any. 0.2mm used here but a smaller layer height would make the top surface smoother.

Material: Any. PLA used here but any can be used

Brim: Would recommend when printing the carrot as the bed contact area is low.