Print Profile(1)
P1P 0.2mm standard, 10% infill, tree support
Designer
2.5 h
2 plates
Open in Bambu Studio
Boost
67
82
3
1
42
12
Released
Description
Hello!
I've created a Minecraft style board that you can write any text you want on. In the files you'll find a model with no text and one with "Man Cave" on it.
You don't need AMS for printing, just 16 4mm x 2mm magnets and superglue. It can be wall mounted and you will need M4 screws.
Filament list:
- Gray: Azure PETG Original Grey
- White: Azure PLA Litho White
- Brown: Azure PLA Wood Cork
Below you will find the assembly steps.
Comment & Rating (3)
All
in your design if you make the lettering same height as one layer it would stop it from tracing it again and again as it prints the solid color probably would cut off a little print time as well. but quality of life is most imp..
The designer has replied
1
Reply
Thanks for the comment and you're right, but luckily in printing time it's not so much and so the end result will be nice
1
Reply
Print Profile
P1P 0.2mm standard, 10% infill, tree support
Looks good
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld