Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
1
2
2
0
5
5
Released
Description
Gonzaga University Bulldogs Coaster
Get your basketball coaster holder here https://makerworld.com/en/models/143053#profileId-155512
Comment & Rating (2)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Worked well.
Concentric top surface might work better though. Had some raised edges from the rectilinear for the top/backing of the coaster
The designer has replied
0
Reply
I had tried that but it leaves a big nasty seam from the center to the edge that I was having to file off. This seemed better.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld