i wanted to try to create a decoration for the door's corner and since is the year of the dragon i tought why not a dragon. it's a very simple design that i used as a test but wanted to share. the dimension are a bit small but you can use uniform scale in the slicer to adjust the size. The model is thin (1.2mm) so it wont use much filament, but if you have a gap between the door frame and the wall you can rescale the Z dimension on the slicer to make it thicker. A wanted to put two of them printed in red facing each other on the entrance corner to bring good luck but i'm currently out of red filament, might update with new picture once i get a new one.