A remix of Denste17's bike mount, which is also a remix of Florian Z's (Weberflo) Multihalter für Thule Chariot. My remix is based on another remix by Philipp Unstoppable (allXages) who added a PLA Version.

Denste17's Mount unfortunately didn't work for me (snap fit broke away) and Philipp's version's connection seemed a little fragile around the flex hole.

So I modified the flex hole position to make the connection a little more rigid (2 walls stronger). In addition I modified the lever in order to be in a (for me) more ergonomic position. Denste17's version had two big fillets on the side, out of which the one laying down on the printbed would always print a little untidy due to the big overhang. Therefore I exchanged the big fillets on both sides for chamfers in order for the model to print a little cleaner.

Printed in PLA+ 0,2 mm layer hight, 3 perimeters, 3 top/bottom layers, 8% gyroid infill is sufficient (in fact you may run into trouble when using too much infill, meaning the lever may break from too much tension). Using Arachne Engine will likely make the lever overhang turn out nicer gathered from my testing.

This remix should work for everybody who wants to print in PLA, but other materials will likely print/work well too!

Thanks to the previous authors' work and enjoy!

I’d appreciate a “like” if you do and look forward to your makes <3