This is an alternative remote control holder for the Philips Hue Remote Control.

It is designed to hold the remote control better and at the same time make it easier to grab it without dropping it.

On the back are three places for adding double sided tape of ~19mm wide and ~1mm thick. This is used to attach the holder to a wall. There is also a round hole of ~24mm for inserting a metal object - for example a coin. This metal object will allow the magnet in the remote to grab on to the holder.

The holder in the photo was printed using Bambu PLA Basic - Jade White. It is slightly translucent which is not ideal given that the copper coin that was inserted via the hole on the back is visible through the plastic.

In addition, the holder was printed on an X1C using the “0.08mm Extra Fine @BBL X1C” setting and “Only on wall on top surfaces” set to “Not Applied”.