Search models, users, collections, and posts
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
20
55
1
0
61
27
Released
Description
Sun chain puller for any light switch or ceiling fan. This attaches to existing or broken chain to add decoration. Also stops chain from swinging around or snapping. This can be printed in multi colors or a glow in the dark filament. I used #6 chain and chain connector to be placed in the sun. There is a pause at layer 75 if using my settings. I pushed my chain and connector in and heard a snap, than resumed print. The tolerances where tight so I made sure nothing moved and watched it print a layer over connector than walked away.
Filament was Overture highlight yellow.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)