Hello, this japanese lamp is very practical for kids room or even in a living room.

Print all the files, the side panels should be printed side down with the 45 degree angle facing up.

Add your light bulb and support of your choice on the base with the wire going through the premade hole. I didn't make hole for the button as I used sensor switch instead.

Glue lampshade paper or paper of your choice to the panels and slide all the panels together, glue the four panel to the base and lastly glue the top panel...et voila!!

Hope you like my lamp and don't forget to comments for any improvements.

Enjoy...Cheers

Tip Designer

Creality