Needed something with a good bit of volume and didn't seem to use a lot of filament. Functions well and am able to clean it out when needed with ease

👍🏻😊

the overhang is quite bad. I’m not sure if its because I didn’t have the lid or door open, but at least it finished. would also like for the print to have a spot for a magnet.

some minor issues on some layer transitions but it's only visible in certain lights, as it's sitting behind the printer anyway it's a complete non issue.

Printed on X1C with ESun Silver PLA+. Tree Supports didnt come off the easiest but were going for efficiency not quality. Also using it for the X1C and the lip is just 1-2mm too high. Overall it does the trick and I am happy with the slim profile.

perfetto anche in pla

its very practical

great design.