Drink Can Dispenser V3 - For All Sizes by SamCui

SamCui

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 6 walls, 25% infill

Designer

88.4 h

11 plates

3.9(8)

Open in Bambu Studio

Boost

Released

Description

Drink can dispenser for all sizes that you could find in the market, and can be printed on only one X1/P1 plate. No support is needed. Suggest applying some instant glue to the joints.

Compared to V2, improved stability and changed dovetails to make alignment much more easy.

Documentation (1)

Bill of Materials (1)

can_sizes_4084bff1-74ab-46cb-9464-46ea33e82562.csv

Comment & Rating (11)

@retnuh

Print Profile

0.2mm layer, 6 walls, 25% infill

Strength Issue:printed great, looks awesome, but as others have mentioned, the little clips in the middle are way too fragile. i was extra cautious from reading the previous comments and 3 still snapped.

@Ralf3d

Boosted

I think it's great that I can choose my size.Everything fitted, the connections should be glued.

@TimoBNC

hey, can you publish the respective dimensions of the final product? Unfortunately, the refrigerators are not the same everywhere. thank you

@tjamz

Print Profile

0.2mm layer, 6 walls, 25% infill

Tabs that interlock the joints are very fragile, joints don't fit together very snug either. A little CA Glue was needed to hold it all together (which was mentioned in the description) Overall though, it is a very functional print

@tjamz

The file prints just fine, well done there! Fits 16oz Kickstart cans perfectly. My only complaint is the tabs that lock the left and right sides together have a couple minor flaws. 1. they are so thin that they break with even the lightest touch (I printed solid, 100% infill density using ABS) 2. They don't "lock" together very well. A dab of CA glue on every joint was necessary. Once the CA has dried I will be doing some light sanding to smooth the joints out and remove any excess glue that may have seeped out of the seems.

@LByL

Print Profile

0.2mm layer, 6 walls, 25% infill

@Fluppi

Print Profile

0.2mm layer, 6 walls, 25% infill

(Edited)

Strength Issue:For me, unfortunately, not usable. I printed the 500ml version, and the connections were too weak. As soon as I put in a few cans, the whole thing completely fell apart. Edit: Also the opening in the front didn't fit for 500ml cans.