Summary

This is a computer monitor vertical stand for the BenQ GL955 18.5 inch monitor.
It has a tilt of 3 degrees. (backwards, of course)

This stand was designed for a monitor with the following dimensions:
Width: ~46cm (for vertical orientation matters, this is the height)
Relevant max depth at the area of the stand: 24.5mm (this is the width of the slot that the monitor slides into)
Relevant bezel width: ~21mm

The base's length is 10cm, I probably could have made it shorter, but I wanted to make sure it's steady. It turned out very steady for my normal desktop needs.

This stand can also be used as a low-profile horizontal stand for a monitor.

This stand will probably work for other monitors in different dimensions. You can resize it to your needs if necessary.
If your monitor has thin bezels, you should take into account that I designed this for a monitor with thick bezels. (about 21mm)

Print Settings

Printer Brand:

Creality

                                            Printer:                      
Ender 3

Rafts:

                                            Supports:                      
No

Resolution:

0.28 is good enough, you can use a better one for a better finish

                                            Infill:                      
20%

Filament:

unknown PLA

                    
                        Notes:                     Print 2 copies, for each side.

I recommend printing it on the side, i.e. with the "triangle" side on the bed, because it worked fine for me.

How I Designed This

I modeled it in Fusion 360 with fairly exact measurements of the monitor, inspired by mtib's design. I really liked his design, it was so simple.
I didn't use his version because I was afraid the dimensions wouldn't fit my monitor and I needed an excuse to get to know Fusion 360 a little.

Thanks, mtib!

I included the original f3d file in case you want to tweak the design to fit your needs.

monitor

monitorstand

monitorvertical