Flashforge Adventurer 5M Pro Top Spacer
Remixed by
Copyright Claim
Flashforge Adventurer 5M Pro Top Spacer
Remixed by
Boost
3
3
5
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
3.7 h
2 plates
Open in Bambu Studio
Boost
3
3
5
4
60
2
Released
Description
Note: Print Profile added for BL printers. Check the raw files for ForOrca&Adventurer5MPlate.3mf for Adventurer 5m Pro profile print
Prevents PTFE tube dragging against the acrylic panel.
I have cut original model 4 pieces with connectors so it can be printed on Adventurer 5M. Use CA glue to secure if you wish but don't have to. This method is better then cutting the ptfe tubing.
To remove the acrylic top; Close the top panel and access through the front and press up in the middle at the back edge to flex the panel up and it slides out very easily. Install to the space with same manner.
ForOrca&Adventurer5MPlate3MF created in orca slicer.
Comment & Rating (5)
All
I just finished printing the first piece and noticed there are no holes for the connecters you've added.
The designer has replied
1
Reply
which 3mf did you use ?
bambu or orca for FF ?
0
Reply
This also fit the 5m (non pro) enclosure print files prodided by FF themselves?
The designer has replied
0
Reply
I dont know, as I dont own one, sorry
0
Reply
Boosted
Great idea, just bought 5m pro and notice this problem. THX!
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld