This is my 3rd attempt at the Trump Mugshot that was requested on a BBL forum  .
I used a photo editor and Hueforge to make this 2D Hueforge art.
I have more and will continue to make Trump-themed prints if people like them .

I have included a text file of filaments and layer swaps. I use Orcaslicer's config and then import the files into Bambu Studio. 
 

I also have listed them below :

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.6
    PLA+ Esun Orange Transmission Distance: 5
    PLA BambuLab Basic Yellow Transmission Distance: 6
    PLA BambuLab Matte Ivory White Transmission Distance: 6

Swap Instructions:
    Start with Charcoal
    At layer #12 (1.04mm), swap to Orange
    At layer #18 (1.52mm), swap to Yellow
    At layer #20 (1.68mm), swap to Ivory White for the rest.