Simplistic and modern headphones/headset holder. Places on desk, and supports almost all types of headphones. This model will only print on printers with a larger print bed. It requires a MINIMUM size of 70mm x 241mm x 30mm (height) Otherwise, you can print it upright, and use supports.

Place the headphones on the holder and the stand will hold the headphones. If the headphones have a cable, make sure that it is quite loose, or else the cable will make the headphones fall

Print tips:

Print on its side, so supports are not needed

Make sure your bed is properly leveled, as it will probably take up almost the whole bed (in one direction)

15-30% infill

Recommended layer height of 0.3 or lower

Hope you like it. If you do, make sure to post a make, and leave a review. If you have any questions, feel free to leave a comment.