A cute baby penguin with an integrated drawer

Notes:

After printing it, I used some very rough sandpaper 40 grit to remove the edges left by Cura's Line support material. Finish it off with some 220 grit.

The drawer may be a little loose, because it lacks a positive locking mechanism. Thus you can layer some Scotch tape on the bottom in the middle of the drawer (I put 25 layers) or so, then it will be tighter.

The face is a tight fit, and you may need to drill the holes out a little for better fit. I do not remember the specs on the fit, but part of it was again, because this was done with rudimentary technology. You will likely have better results, but having a drill and sandpaper handy won't hurt.

I originally assembled this with dollar store epoxy. While this works fine, and I used it for a variety of other similar projects, I no longer recommend this material. It does not adhere well.