Mario Piggy Bank with embedded magnets
VargaMark
Shared by
Copyright Claim
Mario Piggy Bank with embedded magnets
VargaMark
Shared by
Boost
65
109
16
Print Profile(2)
2 Colours - 0.2mm layer, 3 walls, 20% infill
13.6 h
1 plate
1 colour - 0.2mm layer, 3 walls, 20% infill
2.6 h
1 plate
Boost
65
109
16
1
202
76
Released
Description
You'll have to set the slicer to STOP THE PRINT at the top of magnets, before the first layer, that covers the magnets.
In the presliced files I already added the stops to both heights. Remember to add the magnet and then continue the print.
Comment & Rating (16)
All
Great thanks a lot
1
Reply
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
0
Reply
What size of magnets I need?
The designer has replied
0
Reply
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
6x2mm magnets were a bit too tight of a fit for me and pauseing the print for too long trying to fit them resulted in a visible line in the print where the magnets are
0
Reply
Print Profile
1 colour - 0.2mm layer, 3 walls, 20% infill
printed perfectly. thanks!
0
Reply
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
0
Reply
Boosted
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
1 colour - 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
2 Colours - 0.2mm layer, 3 walls, 20% infill
0
Reply
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld