Wall bracket for table. Holes and recess designed to fit Ikea Adils 5-hole table leg and mount using existing screw holes with the leg installed.

My 3D printer lives on an inexpensive Ikea desk. The little legs aren't very strong and the printer causes huge vibrations that show on prints. I tried making braces for the legs, but they were never stiff enough to help with vibrations. This was the latest attempt intending to bolt the table directly to a wall to stabilize against vibrations. Unfortunately the wall studs were not in the right positions so I didn't end up using this bracket. This could also be used to attach custom shelves to the front or back using the leg mounting holes.

Print using additional walls and infill for the extra strength (I use 4 walls and 45% infill on this style of bracket).

Orient either with round surface down for maximum layer strength (support required) or with the shorter side down (no supports) for a better surface quality but lower strength.

Fusion 360 design is provided to use as a basis for other designs.