Dune Worm Towel Holder
Copyright Claim
Dune Worm Towel Holder
Boost
3
7
0
Print Profile(2)
AMS single filament swap TPU and PLA
Designer
51 min
1 plate
No AMS two plates PLA and TPU
Designer
59 min
2 plates
Open in Bambu Studio
Boost
3
7
0
0
3
0
Released
Description
Shai-Hulud holds your towel while you put on the (old) spice.
This towel holder prints in two pieces. The TPU teeth snap into the PLA base. There are three ways to mount onto the wall:
- A single #4 or #6 screw
- Twelve 10x2mm magnets which fit into recesses in the base
- 3M VHB or other adhesive tape
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld
Comment & Rating (0)