Magnetic Towel Holder
Copyright Claim
Magnetic Towel Holder
Boost
5
14
0
Print Profile(2)
AMS single filament swap PLA and TPU
Designer
46 min
1 plate
No AMS two plates TPU and PLA
Designer
54 min
2 plates
Open in Bambu Studio
Boost
5
14
0
0
10
2
Released
Description
This towel holder prints in two pieces. The TPU piece snaps into the PLA base. There are three ways to mount onto the wall:
- A single #4 or #6 screw
- Twelve 10x2mm magnets which fit into recesses in the base
- 3M VHB or other adhesive tape
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld
Comment & Rating (0)