Model

Got tired of having small things on my table so I designed a simple and modern-looking mini drawer for my table. There are two folders of files whether you want to print a shell with two drawers or only need one drawer. The print is simple enough so it can be printed with default settings or with tweaked settings. Personally, I only changed the layer height but otherwise, it is completely printed with default settings.

Note:

• Make sure that the shell is printed laying down (shown in the last pic) for the best outcome. You shouldn't need the use support on any of the files.
• I printed the drawer boxes with brims for better adhesion because I noticed that the corners tend to bend up.
• The connection pieces give some wiggle room between two pieces so if yours' do that… It is completely normal. You can use glue to create a better bond between pieces
• The model is modular so you can stack as many drawers on top of each other as you want. Want 1x3? Print 1x1 shell and drawer then put it on top of 1x2 drawer.

Specifications:

Print Settings:
Layer height: 0.15 mm
Infill: 10%
Supports: No
Rafts: No