Note: If you download the original model without side cutouts for the part fan wire, please replace with the latest STL. This has been updated to correct the part fan hole locations which were too low my 2mm. I also reinforced the lower clips, added cutouts for the par fan wires, and tweaked a few other things.

Replacement Ender 7 hot end shroud / cover with a few tweaks. The hot end fan grill is removed, and the opening enlarged and shifted upward. Hopefully this improves airflow and reduces noise. Some additional venting was also added on top.

Note that the left part cooling blower wiring is routed through the original shroud. The wires need to be disconnected and pulled through the cable sheath or de-soldered from the blower to remove the fan shroud. I opted to desolder, but it's a very tight spot and awkward to do without melting something.