Material Suggestions: While the model can be printed in various stronger materials, PETG is recommended from my side, as the hinge part is very small and fragile. This provides a balance of durability and ease of printing.
Printing Recommendations:
Layer Height: 0.08 mm for a good quality
Nozzle diameter: 2mm
Infill: 20% for sufficient strength without excessive material use.
Is it a replacement of the actual button? How did you take the remote apart? It seems like a lot of force is needed. I have not managed to get my buttons of the remote :)
Yup it is a replacement button. It was quite difficult to take apart, I took my time and was very careful.
https://www.youtube.com/watch?v=285Lsu354wY - I used this video for inspiration, but was much more careful.